Our server will be updated in 5 min., sorry for the bump and inconvenience.

Jongert 2100S

Årgang:  1991

In Verkoophaven, Hollan...

Sejlbåd til salg

6.623.000 DKK

(895.000 EUR)

  • Jachtmakelaardij Nicolaas Witsen
  • Kraspolderweg 2
  • 1821 BW Alkmaar
  • Holland
  • 072-5152727
Quick Contact, log ind Send E-mail

. This Jongert 2100S has been refitted in the last 4 years, which you must have seen. The yacht is in mint condition and is ready for its new owner. General Steering system: Mechanical Whitlock Other: The underwater ship was made bare and rebuilt with 6 coats of primer and 2 coats of antifouling (under the supervision of International paint 2016, inspection report available). Hull and superstructure are painted with two components in 2018. The mast, boom and spiboom have been treated and painted with two component paint system (2019). Centre and rear cockpit. Accommodation Cabins: a spacious owner's cabin with shower and toilet in the back of the ship. Three cabins at the front of the ship Cooker & fuel: electric Engine, electrics, water Engine hours: after revision (before revision +/- 5300 hours) Propulsion: oil-lubricated propeller shaft Water system: hydrophore overhauled Hot water: boiler Water tank & material: 2 x 715 L Waste water tank: 250 L blackwater and 250 L greywater. Flushing system for the tanks. Waste water drain pump renewed. Other: The engine was completely overhauled in 2010, new pistons, piston bushes, bearings etc. Two new alternators for charging the service batteries and starter batteries. Starter battery and generator battery renewed. All pipes, filters and taps in engine room renewed. Exhaust valve renewed. New cooling generators and cooling pipes. Rig and sails Genoa: 151,1 m2 Genoa reefing system: hydraulically Jib: 97,5 m2 Furling foresail: hydraulically Other: Genoa sheets and 2 halyards. Hydraulic control by means of deck switches and/or remote control. Equipment Anchor windlass: Anchor winch connection renewed and equipped with a new hydraulic motor Other: Teak deck partially renewed, all seams min. 6 mm deep and rubberized again. Safety Other: There is a full 4-part manual of all systems and equipment. Most technical data and design drawings, photos, procedures etc. are stored in the computer


Materiale / Målestok









Motor / teknisk information


OM 636